I'd be willing to part with my Q9m (with lime green housing) as soon as my Nap can be activated, hopefully very soon. You'll probably find one on eBay before then, but just throwing that out there![]()
This is a discussion on How to flash to the Generic/USCC combination firmware with working MMS and data within the Moto Q Hacks forums, part of the Motorola Q Software category; I'd be willing to part with my Q9m (with lime green housing) as soon as my Nap can be activated, ...
I'd be willing to part with my Q9m (with lime green housing) as soon as my Nap can be activated, hopefully very soon. You'll probably find one on eBay before then, but just throwing that out there![]()
Dialing *228 and updating your roaming capabilities will not alter any of the programing correct? I do not want to reflash everything again. I do want most current tower locations, but don't want verizon to program my phone obviously.
Thanks
benfoster1977 (06-17-2009)
Just had the txt messages app freeze up on me and had to pull the battery. This is the second time it's happened. The first time was while receiving a message and this time was while sending. Anyone else had this happen?
Ok, posted this somewhere else with no luck or help.
I flashed to the generic/uscc setup, and when I run any gps software my phone sits there for a few seconds then restarts. I've tried reflashing everything again, still does it. Yes the data is working, since that was the only question I was asked the last time I asked for help.
This is probably a dumb question as I haven't looked into this flash very much, but will it enable GPS use on US Cellular?
Has anyone done this with a Vista 32bit pc? Any specific issues?
Also, does anyone know if anything weird will happen with MMS since my phone and service are originally alltel which has been recently changed to verizon in my area?
What is the next step?